Triplett 9007 Manuel d'utilisateur télécharger pdf (Page 36)

Page 35

7.10 Measuring Capacitance:

WARNING!

Do not apply voltage or current to the meter when it is set

to the Capacitance “F ” ranges. Do not connect a charged capacitor to

the meter. Doing so may damage the meter or injure the user.

7.10.1 Connect the black test lead to the COM jack and the red test

lead to the VOLT / DIODE / OHM / CAP “V Ω CAP” jack.

7.10.2 Set RANGE switch to the F position appropriate for the

measurement to be made.

7.10.3 Connect the test leads to the capacitor to be measured.

Observe proper polarity (if appropriate). Read value from

the LCD display.

7.10.4 If the display indicates overrange, i.e. “1- - -”, rotate the

RANGE switch to the next higher position and observe the

reading on the LCD display. If the RANGE switch is already at

its highest position (i.e. 200u F), and the reading exceeds

20.0, it should be considered inaccurate.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 47 48

Pas de commentaire

Triplett 9007 Manuel d'utilisateur Page 36