Triplett 2000 Manuel d'utilisateur télécharger pdf (Page 19)

Page 19

3.7.3 Fuse Replacement

3.7.3.1 Locate the two fuses on the Input Scaling Board (BD200).

3.7.3.2 Using a small, flat blade screwdriver, gently lift the installed

fuse from its clips. Be careful so as not to bend the fuse clips.

3.7.3.3 Install a new fuse of the proper type. See Section 7.4 for

the correct type. Be certain that the fuse is securely seated in the

fuse clips.

3.7.4 Case Back Installation

Re-install the case back being careful not to pinch any wires. Tighten

the thumb screw finger tight.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 47 48

Pas de commentaire

Triplett 2000 Manuel d'utilisateur Page 19