Triplett 2000 Manuel d'utilisateur télécharger pdf (Page 18)

Page 18

3.7 Battery and Fuse Replacement

3.7.1 Case Back Removal

3.7.1.1 Disconnect any test leads connected to the Test Set and

place the Range Switch in the OFF position.

3.7.1.2 Remove the case back by turning the large thumb screw in

the center of the case back counter clockwise.

3.7.2 Battery Replacement

3.7.2.1 Remove the D-cell and two 9V alkaline batteries under the

white insulator if they are installed.

3.7.2.2 Install fresh batteries in the clips provided. The D-cell is

oriented with the positive to the small white dot on the meter back.

The 9V batteries can only be installed one way. They must both be

replaced at the same time.

3.7.2.3 Place the 9V batteries into the holders making sure that

the white insulator covers them.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 47 48

Pas de commentaire

Triplett 2000 Manuel d'utilisateur Page 18