Triplett 310 Manuel d'utilisateur télécharger pdf (Page 13)

GENERAL INSTRUCTIONS

Control Locations

For a diagram of the Model 310 / 310-C, please refer

to page 14.

Test Leads

Check the test leads periodically. Leads that are worn,

have damaged insulation, damaged plugs, damaged

probes or loose parts should be replaced.

The following section should be read carefully. It con-

tains instructions and precautions to be observed in

making measurements with the tester.

The alligator clips provided with the tester fit over the

end of the test probes. When measuring high volt-

age, these alligator clips allow measurement without

handling the test probes. ALWAYS SHUT OFF THE

POWER source before attempting to connect alligator

clips.

Range Selection

When the approximate value of the quantity being mea-

sured is not known, ALWAYS START ON THE HIGH-

EST RANGE. For greater accuracy, choose the range

which will allow readings to be taken in the upper (right

hand) portion of the scale. See Operation Chart on

page 25.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 33 34

Pas de commentaire

Triplett 310 Manuel d'utilisateur Page 13